Table of Contents
Why does my Range Rover lowers when parked?
Auto access height automatically lowers the electronic air suspension to the access height setting when the vehicle is parked. The suspension height has to be set at the normal height setting. The transfer case has to be engaged in high range.
How do you reset the EAS on a Range Rover P38?
Range Rover P38 EAS Reset Tool Just plug it in and within 30 seconds any soft faults logged in the EAS ECU will be read and reset. The tool uses the dashboard display to inform you of the progress (MAX 35MPH -> EAS MANUAL -> Faults and Display cleared. Works on all P38 Range Rovers produced between 1994 and 2002.
How do I keep my Range Rover suspension low?
If a door is open, press and hold to raise the suspension height. The button’s LED indicator lamp illuminates during suspension height adjustment and extinguishes when complete. Down button: Press and release to lower the suspension height. If a door is open, press and hold to lower the suspension height.
How do I reset my Range Rover transmission?
Key on, hold throttle to the floor for 5 seconds. While keeping throttle depressed, turn key off but do not remove. Take your foot off the throttle. Wait a few minutes.
What is a P38 Range Rover?
It included an updated version of the Rover V8 engine, with the option of a 2.5-litre BMW six-cylinder turbo-diesel. It is usually known as the Range Rover P38 or P38A outside of Land Rover, after the office building in which the vehicle development team was based.
How do you reset a Range Rover computer?
How do I perform a reset, when my screen is blank?
- To reset the device, simultaneously press the Power on and Volume up button for 10 – 12 seconds.
- The device will power down and then automatically reboot.
- Device will now power on, perform and charge as expected.
Can you drive with suspension fault?
Don’t panic! This message does mean the electronic air suspension has stored a suspension fault but you can still drive normally on the freeway and surface streets.
Why does my Range Rover suspension sag over night?
I speak from the experience of wearing out two with a slow leak. Replace the front valve block. its cheaper & easier than replacing struts and more likely the cause. IF you pull the fuse in the engine bay for the suspension and watch it over night, if the back is sagging evenly it is the rear valve block.
How does an air suspension system work on a Range Rover?
Air suspension systems also rely on computers to control them. Ride height sensors at each wheel constantly analyze dips and bumps in the road. They send these readings to a special suspension computer, called a control module. The computer calculates how much air is needed in each air spring.
How does the air compressor work in a Range Rover?
The compressor pushes pressurized air through air lines into the air springs, inflating (or deflating) them to smooth out the ride. The cycle continues over and over throughout each journey in your vehicle. Simple, right?
How does the EAS work on a Land Rover?
The EAS will level itself to make the sensors read the values as stored during calibration.