Where is the windshield wiper control module located?

Where is the windshield wiper control module located?

Location. The wipe control module is mounted under the driver’s side dashboard, next to the door buzzer box. It is a black module with two white, five-pin connectors plugged into it, and a ground wire screwed onto the side. It is normally secured with two screws, but it may also simply be taped in place.

How do I know if my wiper switch is bad?

Common signs include windshield wipers not turning on or off, not changing speed or settings, and the turn signals not working.

How do you change a windshield wiper module?

Part 1 of 1: Replacing the windshield wiper module

  1. Materials Needed.
  2. Step 1: Locate the wiper control module.
  3. Step 2: Disconnect the negative battery cable.
  4. Step 3: Access the control module.
  5. Step 4: Disconnect the wiper module electrical connector.
  6. Step 5: Remove the control module mounting fasteners.

Where is the wiper relay?

The wiper relay is unique in that it’s found inside the wiper control handle which often has selector switches giving drivers multiple settings for their windshields.

How do I reset my windshield wipers?

Your wipers may need resetting due to loosening up over time, or being forced out of position when an abnormal amount of stress was placed on the wipers, such as clearing large chunks of ice. Resetting the wipers involves removing the wiper linkage and manually placing the blades in the right position.

Where is the windshield wiper fuse located?

Locate the windshield wiper fuse The wiper fuse is usually located in the fuse box inside the passenger cabin.

How much does it cost to replace a wiper switch?

Windshield Wiper Switch Replacement Cost – RepairPal Estimate. Labor costs are estimated between $57 and $72 while parts are priced between $135 and $148. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.

What happens when a wiper relay goes bad?

When the relay is faulty, the windshield wipers will only work at the same speed that the last relay signal was sent. If you make a change in the settings and the wipers don’t react, it’s most likely due to a malfunction in the intermittent wiper relay.

How do you change a windshield wiper relay?

How can I repair a wiper relay?

  1. Necessary material.
  2. Step 1: Find your relay. Many newer car models may have multiple locations for fuses and relays.
  3. Step 2: Remove the relay. Remove the contact with the contact in the off position.
  4. Step 3: Install the new relay.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top