Table of Contents
Where is the VSS sensor located?
The Speedometer Vehicle Speed Sensor (VSS) is located in the transmission housing on the passenger side output flange. Automatic Transmission The Vehicle Speed Sensor (VSS) is located on the right side of the transmission near the output shaft.
How can you tell if VSS is bad?
One of the most common signs of a bad speed sensor is abnormal automatic transmission operation. If the VSS is faulty, the transmission may exhibit symptoms such as delayed shifts, hard shifts, and limited gear operation.
How do you replace VSS?
VSS Replacement
- 1) Loosen and remove negative battery cable.
- 2) Locate the faulty speed sensor and disconnect the speed sensor connector.
- 4) Check the connector wiring to insure there are no breaks or exposed wire.
- 5) Verify O-ring is installed on new sensor.
- 6) Install and tighten new sensor.
What does a VSS sensor do?
The vehicle speed sensor (VSS) measures transmission/transaxle output or wheel speed. The ECM uses this information to modify engine functions such as ignition timing, air/fuel ratio, transmission shift points, and to initiate diagnostic routines.
How do I fix code P0500?
What repairs can fix the P0500 code?
- Vehicle speed sensor drive gear replaced.
- Repair or replacement of the wiring harness.
- Vehicle speed sensor replaced.
- Poor electrical connection resolved.
What is the VSS sensor?
Vehicle Speed Sensors The vehicle speed sensor (VSS) measures transmission/transaxle output or wheel speed. The ECM uses this information to modify engine functions such as ignition timing, air/fuel ratio, transmission shift points, and to initiate diagnostic routines.
How much does it cost to replace a speed sensor?
To replace the speed sensor, you are going to pay, on average, between $330 and $380. The labor should only cost you between $80 and $100, while parts will run you about $265.
How do you test for VSS?
You can test your VSS to make sure it’s functioning properly by using a device called a multimeter. Start by disconnecting and removing the VSS from your engine so you can test it. You can then connect it to a multimeter and set the multimeter to the AC setting.
How do you check VSS?
Solution
- Open a command window.
- At the command prompt, type vssadmin list providers, and then press ENTER.
- Confirm that Microsoft VSS provider is listed as:
- Type vssadmin list writers at the command prompt, and then press ENTER.
- Confirm that all the VSS writers are showing:
How does the VSS work?
Basic Functionality of the VSS The VSS is connected to a speedometer cable and positioned between the axle and the wheel of a vehicle. This voltage is then transmitted to a computational device that calculates the speed proportional to the moving vehicle.
Can you drive with a P0500 code?
P0500 will not prevent the vehicle from operating but it may shift roughly causing some discomfort when driving. If the ABS system and Traction Control System (TCS) do not operate, care should be taken when driving especially during adverse weather conditions.