Where is the OBD port on a Jeep?

Where is the OBD port on a Jeep?

The obd port on the Jeep Liberty is located under the driver’s side dash. This is for connecting an OBD reader, something that most mechanics will have, and checking the trouble codes.

What year did jeep go to OBD2?

OBD2 was introduced on all 1996 and newer model year passenger cars and light trucks sold in the United States.

Do jeeps have OBD2?

But before we proceed, you need to determine the OBD-2 protocol of your Jeep. Yes, all vehicles manufactured beginning 1996 onwards are all OBDII compatible, but they don’t necessarily use the same OBD2 protocols.

Where is the OBD port in a 2004 Jeep Wrangler?

On the bottom of the plastic panel between the steering wheel and the door by where your legs extend to the pedals. You’ll see the plug down there.

Where is the code reader on a Jeep JK?

Step 1 – Locate OBD-II port The port on your Wrangler and most other vehicles is under the dash on the driver’s side. Figure 3. OBD-II port on Wrangler.

Does My car support OBD2?

All cars and light trucks built and sold in the United States after January 1, 1996 were required to be OBD II equipped. In general, this means all 1996 model year cars and light trucks are compliant, even if built in late 1995.

Do all cars have an OBD port?

You can find an OBD2 port in all gas vehicles manufactured since 2001 in the European Union, and in all vehicles from 1996 onwards in the USA. Therefore, if you own a car manufactured in recent years, it will be equipped with an OBD2 port!

Where do you plug in a diagnostic tool on a Jeep Wrangler?

Where is the OBD plug on a Jeep Grand Cherokee?

OBD connector location for Jeep Grand Cherokee WJ (1998 – 2005) You will find below several pictures which will help you find your OBD connector in your car. The OBD socket is located under the steering wheel on the left. Go to the OBD2. scanner for JEEP. The OBD2 plug is above the hood lever.

Where is my OBD2 port in my car?

The norm states that the port must be located inside the vehicle passenger compartment. Depending on the make and model, it may or may not be easy to locate. To diagnose your vehicle yourself, download our EOBD-Facile car diagnostic software. Use our search engine below to locate your OBD2 port!

What is the Check Engine Light code for a jeep?

P1475Auxiliary 5 Volt Output Too High P1476Too Little Secondary Air P1477Too Much Secondary Air P1478Battery Temp Sensor Voltage Out Of Limit P1479Transmission Fan Relay Circuit Open Or Shorted P1480PCV Solenoid Valve Open Or Shorted – Read Our Article on Automotive Circuit TestingFor Help With This Jeep Check Engine Light Code

Where is the 16 pin connector on a car?

Since the implementation of the OBD standard, each vehicle has a standard 16-pin connector, as described on our OBD presentation page. The norm states that the port must be located inside the vehicle passenger compartment. Depending on the make and model, it may or may not be easy to locate.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top