What is fault 49 on Fisher and Paykel Aquasmart?

What is fault 49 on Fisher and Paykel Aquasmart?

@stevew Error Fault Condition – Water Inlet Valve Fault. Repair or Check – Unplug the washer from power. Reconnect any non secure wires on the water inlet valve. Replace the wire harness if it is found to be damaged.

How do I reset my F&P washing machine?

You can reset your washer to the settings it left the factory with:

  1. Enter Option Adjustment mode (refer to ‘Option Adjustment’).
  2. Select the ‘Delicate’ cycle.
  3. The display will show . Touch and hold for 3 seconds to reset your washer to its factory settings.

Why won’t my washer stop filling up with water?

The reason your washer will not stop filling could be because the hose has either clogged, fallen off, or gotten a hole in it. If there is a hole in the hose, it will reduce the pressure and cause the water level switch not to shut off power to the water inlet valve.

How do I reset my Fisher and Paykel Quicksmart front loader?

If you’d like to reset your Fisher and Paykel EcoSmart washing machine to the settings that it left the factory with, start by entering Option Adjustment mode (outlined above). Then, press the ‘Delicate’ cycle and hold for three seconds. This action will reset the device to factory defaults.

Why does my washing machine keep stopping and beeping?

You could be having an intermittent power failure. Check the outlet cord to make sure that it is plugged in properly. Check the power cord for damage. Excessive suds could be causing this problem in some models of washers.

Why does my Fisher and Paykel washing machine keep beeping?

Your machine is checking that the water has drained before spinning. Your washer will beep if you have used ‘No Spin’ and at the end of the cycle. If your machine is beeping continuously or giving a musical series of beeps, refer to the ‘Before you call for service’ section.

How do I put Fisher and Paykel into diagnostic mode?

Diagnostic Mode. With Power off, press/hold Keylock, then press Start/Pause at the same time for 5 seconds. Release the buttons when it powers-on. Press Power once.

What makes The AquaSMART washer different from other washers?

Your AquaSmart™clothes washer works differently from a conventional washer. It is a “High Efficiency” machine utilising innovative technology to wash in less water and take great care of your clothes.

When does fault 37 appear on a Fisher and Paykel washing machine?

Problem: This is one of the most common Fisher and Paykel washing machine fault codes. Fault 37 appears when the water has not drained from the drum. Solution: 1.

How does the Fisher and Paykel AquaSMART washer work?

In the High Efficiency mode the AquaSmart™then fills with just enough cool water to lift the clothes off the low profile agitator so when it rotates, the clothes gently roll over each other. This wash gives you the benefit of water savings, using similar quantities of water to most front loaders.

What to do if you have a fault in your washing machine?

The first two areas to check are the clutch and the pressure tube. If these two appear correct, then the fault could be in the pressure sensor in the Motor Controller module. Solution: 1. Check that there are no foreign objects stuck in the clutch that are preventing the bowl to engage.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top