Should I use threadlocker on brake bolts?

Should I use threadlocker on brake bolts?

The repair manual says “Apply a high temperature thread locker (Loctite 272® or equivalent) to the caliper support bracket fasteners. If Loctite 272® (or equivalent) is not available, new caliper support bracket fasteners must be used.”

Do you grease caliper bolts?

Before putting the caliper bolts back into their spot, they need to be lubricated properly. Brakes are one of the hottest places for your car, so you’re going to need high-temperature grease. This lubricant is synthetic and can withstand the high temperatures that your car’s brakes will reach.

How much torque should a caliper bracket be?

The front brake caliper bracket should be tightened to 70 ft/lbs and the rear should tightened 85 ft/lbs. The caliper bolts have a torque spec of 44 ft/lbs and 23 ft/lbs in the rear.

What is the difference between red and blue Loctite?

Loctite threadlockers are primarily designed to prevent fasteners from leaking or loosening from vibration. The difference between red and blue threadlocker is a matter of strength and removability. Loctite threadlocker blue is designed to easily be replaceable with common tools, whereas red is a more permanent fix.

Do you need to grease caliper pins?

Before we re-insert the caliper guide pins into the caliper housing, they need to be properly lubricated. But remember, it’s always best to check your vehicle’s service manual before doing this kind of work. You’re going to need some high-temperature grease. They should slide right in if you used enough grease.

What direction do you turn caliper bolts?

Basically, (at least on the passenger side) you should be pushing the ratchet down and away from you (towards the rear of the car if you’re facing the rear) to loosen the caliper bolts.

What are torque specs for front brake caliper?

Torque specs for front brakes caliper mounting bracket bolts torque 85 ft lbs torque caliper bolts 26 ft lbs.. Drain brake fluid to ½ full level in reservoir. Remove the front wheels. Remove the front brake caliper assembly. Remove the 2 anti-squeal shims from each of the 2 brake pads. Remove the wear indicator from each of the 2 brake pads.

How do you Torque the slide pins on a brake caliper?

Torque the slide pins as follows: Install new gaskets and connect the brake hose to the caliper with the banjo fitting bolt. Torque the fitting bolt 22 ft-lb (29.4 Nm). Fill the reservoir with brake fluid.

How to change torque settings on front brake?

Torque settings 1 Remove the front wheels. 2 Remove the front brake caliper assembly. 3 Remove the front brake pads. 4 Remove the 2 bolts and caliper mounting bracket. 5 Place match marks on the disc and axle hub. 6 Remove the front wheel disc. More

Can a torque wrench be used to break loose fasteners?

Experts also advise against using a torque wrench to break loose fasteners because the sudden shock when the fastener breaks free may affect calibration.