How much does it cost to replace valve stem seals in a BMW?

How much does it cost to replace valve stem seals in a BMW?

Most dealerships charge upwards of $8,000 to replace the valve stem seals. As a BMW specialist, we can do it for much less. Nearly half the cost, actually! And if you are not sure about the valve stem seals being a problem on your car, just start it up and let it idle for 10 minutes or so.

How much does it cost to replace valve stem seals?

A valve stem seal replacement cost will vary. On average the cost will run between $900 to $1,800. The cost will depend on the make and model of the vehicle as well as where you take the vehicle.

What happens if you don’t replace valve stem seals?

If the valve stem seals have deteriorated enough; the blue-white exhaust smoke; will last longer after start-up and acceleration. Yet the smoke will eventually disappear; after long engine operation or during periods of hot weather. Bad valve seals nearly always show, an intermittent problem of oil burning.

How much should a valve job cost?

The average cost for a valve adjustment is between $246 and $336. Labor costs are estimated between $220 and $278 while parts are priced between $26 and $58.

Can you change valve seals without removing the head?

After miles of service, the valve seals in the cylinder head of your vehicle wear out and become brittle. On most vehicles, it’s possible to replace these valve seals without removing the head. With the right tools, learn to perform this job in your garage and save a lot on repair costs.

How much does it cost to replace engine seals?

Amade of either rubber of silicone, this main seal is crucial in keeping the liquid where it should be, and typically requires a replacement to be fixed when getting damaged The rear main seal replacement cost is usually between $410 and $517, with labor costs estimating between $388-$491 of the total.

How much does it cost to repair a valve?

Between $246 and $336 is the average cost of a valve adjustment. The labor costs are between $220 and $278 while the parts cost between $26 and $58.

How much does it cost to replace valve stem seals on a BMW?

Most dealerships charge upwards of $8,000 to replace the valve stem seals. As a BMW specialist, we can do it for much less. Nearly half the cost, actually! And if you are not sure about the valve stem seals being a problem on your car, just start it up and let it idle for 10 minutes or so.

How much does it cost to replace a valve guide seal?

The good news is the cost of the parts for valve guide seals is between $30 to $100 on average. The bad news is that you are looking at about 2 to 4 hours of labor if you take your vehicle to a mechanic.

Can a stem seal be replaced on a Toyota?

In addition to preventing your car from smoking like an old Toyota at a red light, you can do your engine a huge favor by getting the stem seals replaced. You will prevent damage to the catalytic converters (a very expensive repair if they are damaged), prevent oil consumption, improve rough idle, and can turn off certain check engine light codes.

What happens when you have a bad valve guide seal?

A bad valve guide seal will also have a tiny gap in it after it’s been in the cold for a while. This means that when you start a cold engine, that little bit of oil gets sucked through the seal gap into the combustion chamber. The result will be a cloud of blue-white smoke coming out of the tailpipe when you first start the car.