How do you loosen the brake drum adjuster?
Which way do you loosen drum brake adjuster?
- Locate the access hole on the outside of the brake drum.
- Turn the brake drum so that the access hole is aligned with the drum’s adjuster screw.
- Turn the adjuster screw counterclockwise until it comes to a halt.
- Pull the drum off of the wheel.
Which way do you loosen drum brake adjuster?
Turn the adjuster screw to loosen the shoes. Locate the access hole on the outside of the brake drum. Turn the brake drum so that the access hole is aligned with the drum’s adjuster screw. Turn the adjuster screw counterclockwise until it comes to a halt.
How do you loosen drum brakes?
What would cause a drum brake to stick?
One of the most common causes of one or two wheel lockup on drum brake equipped vehicles is the service and/or parking brake adjustment. If the parking brake system is not de-adjusted properly before the brake shoes are adjusted it will cause the rear brakes to engage too soon.
What’s the best way to remove a brake drum?
Disassembling the Drum Turn the adjuster screw to loosen the shoes. Unscrew the brake drum if needed. If you’re having trouble, use a screwdriver and rubber mallet. Alternatively, remove the brake drum with a brake drum puller.
What to do if your drum adjuster is stuck?
In this case the drum adjuster was stuck so first try to get it off by wiggling back and forth. Then spray penetrating oil to remove rust between the drum and the seat. Then hit it with a hammer hard. This should free the drum if it is just rusted on.
Where is the adjuster screw on a brake drum?
Turn the adjuster screw to loosen the shoes. Locate the access hole on the outside of the brake drum. Turn the brake drum so that the access hole is aligned with the drum’s adjuster screw. The adjuster screw is large and slotted, and is located beneath just beneath the centerline that runs horizontally across the back of the drum.
Where is the access hole on a brake drum?
Locate the access hole on the outside of the brake drum. Turn the brake drum so that the access hole is aligned with the drum’s adjuster screw. The adjuster screw is large and slotted, and is located beneath just beneath the centerline that runs horizontally across the back of the drum.