Table of Contents
How do I reset my Electrolux Time Manager?
First, you should perform a general reset of the machine. Turn the machine off at the powerpoint, wait for one minute, and then turn it back on. If you see no change, you can try a Master Reset. This will reset all of the onboard componentry and is often successfully used by appliance technicians.
How do you run a diagnostic test on an Electrolux washing machine?
Electrolux Diagnostic Mode * Press the Cancel button to enter standby mode and enable diagnostic entry. * Within 10 seconds after pressing Cancel , press any button to wake up the control. button under the display simultaneously for 3 seconds to enter the diagnostic mode.
How do you unlock Electrolux washer?
Pause the cycle and wait for 2-3 minutes. If the door does not unlock then the cycle should be cancelled and a spin/drain cycle selected. Once the appliance has drained the water in the drum and finished the cycle, the door will open with 2-3 minutes.
Why does my Electrolux washing machine keep stopping?
Common solutions for: Electrolux Washer stops mid cycle If the door lock is defective, the washer may stop mid cycle. The door lock can fail either mechanically or electrically. Inspect the door lock for damage. If the door lock is damaged or does not latch properly, replace it.
What is Electrolux Time Manager?
Created to adapt to busy lifestyles, Time Manager puts you in control of every wash. Featuring both a variable wash time and delayed start, this convenient feature lets you select the time you want your wash to end. You can do your wash whenever it suits you.
How do you reset a front load washer?
How to reset the washing machine:
- Press POWER to turn the washer off.
- Unplug the washer from the power outlet or turn the circuit breaker to the unit off.
- With the power disabled, press and hold the START/PAUSE button for 5 seconds.
- Plug the washer back in, or turn the circuit breaker back on.
How do you fix an E11 on an Electrolux washing machine?
Resolution
- Check the water supply to ensure that the water pressure is proper.
- Clean the filter in the inlet hose next to the tap.
- Ensure the correct position of the drain hose.
- Ensure correct drain height.
- Clean the pump and filter.
- Check for blocked drain.