Can you inject valium 10mg?

Can you inject valium 10mg?

Do not inject this medication into an artery or into the skin. This medication may be available in a vial, ampule, pre-filled syringe, or pre-filled syringe with autoinjector. The autoinjector automatically delivers a dose of 10 milligrams deep into the muscle. It cannot be used when a lower dose is needed.

How do you administer Valium?

Intramuscular: Diazepam Injection, USP should be injected deeply into the muscle. Intravenous use: (See WARNINGS, particularly for use in children.) The solution should be injected slowly, taking at least one minute for each 5 mg (1 mL) given. Do not use small veins, such as those on the dorsum of the hand or wrist.

Where do you inject valium?

This medication is given by injection into a vein or deep into a muscle as directed by your doctor. You should be closely monitored for several hours after receiving this medication.

Are you supposed to dilute Valium?

Do not mix or dilute diazepam with other solutions or drugs in syringe or infusion container. If it is not feasible to administer diazepam directly intravenous, it may be injected slowly through the infusion tubing as close as possible to the vein insertion.

What happens if you inject Valium pills?

Sharing needles is one of the predominant causes of diseases like HIV and AIDS. Hepatitis is also a common side effect of intravenous Valium use. Overdose and overdose-related death. Injecting any drug directly into the bloodstream increases the risk of death by overdose significantly.

How long does a Valium shot take to work?

By increasing the effects of this brain chemical, Valium helps reduce anxiety, relax muscles, and increase drowsiness. Valium can be taken by mouth, injection, or rectal gel. 1 When administered via injection, valium takes just one to five minutes to take effect.

Can diazepam be mixed with normal saline?

In general, diazepam should not be mixed or diluted with other drugs or added to IV fluids. However, if IV infusion is required, diazepam in doses up to 20mg can be added to at least 250ml of 5% dextrose or normal saline. Do not use any solution that is cloudy.

Can diazepam be diluted before iv injection?

What’s the best way to give diazepam injections?

Intramuscular: Diazepam Injection should be injected deeply into the muscle. Intravenous Use: (See WARNINGS, particularly for use in children.) The solution should be injected slowly, taking at least one minute for each 5 mg (1 mL) given. Do not use small veins, such as those on the dorsum of the hand or wrist.

What kind of preservative is in diazepam injection?

Each mL of this sterile injection contains 5 mg diazepam compounded with 40% propylene glycol, 10% alcohol, 5% sodium benzoate and benzoic acid as buffers, and 1.5% benzyl alcohol as preservative. Diazepam is a benzodiazepine derivative.

Can you use a pill as an injectable solution?

You should not use any pill to make an injectable solution. For one thing, your intended drug is likely insoluble in water in the pill. Second, the binding agents, dyes, and so forth can be very harmful. Some people who inject pills intra-muscularaly (I.M.) report painful hard lumps in the area near the injection point for days or weeks afterwards.

What are the side effects of diazepam injections?

In these cases, diazepam was being used to treat alcohol withdrawal symptoms at doses greater than 900 mg/day. Propylene glycol toxicity can cause acute tubular necrosis (which can progress to multi-organ failure), mental status changes, hypotension, seizures, and cardiac arrhythmias.