Table of Contents
Where is the starter on a Jeep YJ?
The starter is at the bottom of the motor toward the rear ahead of the transmission. Unbolt the positive wire from the solenoid on top of the starter. The ground is bolted in with the bottom bolt, so it will be removed when you undo the bottom bolt.
How much does it cost to replace a starter on a Jeep?
Jeep Wrangler Starter Replacement Cost Estimate. Labor costs are estimated between $78 and $98 while parts are priced between $260 and $280.
Why is my Jeep Wrangler not starting?
While there are a variety of reasons your Jeep Wrangler won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter.
How do you change a starter on a Jeep?
- Step 1 – Disconnect battery. Before attempting to remove the starter, disconnect the battery.
- Step 2 – Lift and support vehicle (optional)
- Step 3 – Remove starter.
- Step 4 – Install new starter.
- Step 5 – Connect battery and start vehicle.
How do you change the starter in a car?
Step 1 – Lift the hood and remove the negative battery cable from the battery making sure the cable end is clear of the battery to avoid an accidental connection. Step 2 – After the battery has been disconnected, remove all access shielding and covering to expose the starter terminals on the solenoid.
How did the starter motor change over time?
Starter motors have gone through many changes as they have evolved from a hand crank protruding from the front of the vehicle. The starter motor became an industry standard soon after the first internal combustion engine was used a motor car.
When did the Jeep Wrangler YJ come out?
For the 1987 model year, AMC introduced the first Jeep Wrangler (YJ) to the market, which Chrysler continued to produce after the buy out in 1987. It replaced the AMC CJ-7, with very little change in terms of the body and frame. The most notable, and controversial change was the square headlamps.
What causes a car starter to stop working?
Battery cables can cause starter problems as well, inspect the cables for corrosion, melted or bulged insulation, a starter’s lifespan can be shortened if a high resistance connection exists. Starter motors have gone through many changes as they have evolved from a hand crank protruding from the front of the vehicle.