Can I repair a throttle position sensor?

Can I repair a throttle position sensor?

Throttle position sensors failure is fairly common. The average lifespan of a throttle position sensor is just over 80,000 miles. There is no maintenance for a throttle position sensor — it simply needs to be replaced after it stops working correctly.

How do you reset throttle position?

How to Reset Throttle Position Sensor

  1. Put the key in the ignition.
  2. Turn the key to the On position, without cranking the engine. Wait a few seconds, then turn it off.
  3. Repeat the second step.
  4. Crank the engine.
  5. Pull the parking brake.
  6. Set the gear lever in Drive.
  7. Wait 5-10 minutes.

What controls the throttle position?

A throttle position sensor (TPS) is a sensor used to monitor the air intake of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. Related to the TPS are accelerator pedal sensors, which often include a wide open throttle (WOT) sensor.

How can I Reset my throttle position sensor?

Reprogramming or resetting your sensor can sometimes solve these issues. This step can also be necessary when you install a new sensor. The easiest way to reset your throttle position sensor is to unhook the negative cable from your battery for up to five minutes or to remove the fuse for your engine control module.

How much does it cost to fix a throttle sensor?

A throttle sensor is no motor swap but it could still get tricky. Depending on what type of vehicle you have this job could get expensive. If your vehicle has the throttle out in the open in a visible and accessible area then the job shouldn’t be too hard and it could cost you under $500 fix with parts and labor.

When to remove the throttle body of your car?

One thing to remember is that the throttle body can only be removed when it is cold. Once it gets cold, feel free to start disassembling its parts: The plastic-covered choke of the electric motor that is removed by pressing the latch; The motor rotor magnet (do not forget to mark its position relative to the body with a marker);

Can a bad throttle position sensor cause stalling?

Similarly, if your engine struggles to idle efficiently, it could also be a result of a damaged throttle position sensor. Stalling, surging, or hesitating while idling all can be caused by this unassuming sensor. The best way to determine if these issues are caused by your throttle position sensor is to go to the source.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top