How do you fix a Hermle clock?

How do you fix a Hermle clock?

Move the minute hand (long hand) clockwise or counterclockwise to set the clock to the correct time. The clock will strike the number of each hour, and will strike once on the half-hour. If the clock is striking the wrong hour, move the hour hand (short hand) to point to the hour that the clock just struck.

Can you use WD40 on clock movements?

Using substitutes like WD40 can actually damage your clock’s movement. Brass and steel are used in clocks because when properly lubricated with the right oil it forms a perfect bearing.

Can I use 3in1 oil on my clock?

How often should a clock be oiled? Products that you should NEVER use to oil a clock: WD-40, silicone lubricant, kerosene, graphite, sewing machine oil, motor oil, 3 in 1 oil or mineral oil. Clock oil is highly refined oil and it is engineered specifically for clock use .

Can you use WD40 on a clock?

USE THE CORRECT OIL Just like it’s not a good idea to cook with motor oil you don’t want to oil your clock using the wrong oil. Using substitutes like WD40 can actually damage your clock’s movement. Brass and steel are used in clocks because when properly lubricated with the right oil it forms a perfect bearing.

Where are Hermle clocks made?

Germany
Hermle offers an absolute “Made in Germany” guarantee. Hermle Mechanische Uhrwerke und Drehteile GmbH & Co. KG has nearly a century of experience in the production of large mechanical clocks (grandfather clocks, table clocks, wall clocks) and mechanical clockworks.

Is WD40 good for clocks?

What kind of oil do you use on a cuckoo clock?

synthetic oil
However, according to various websites, any synthetic oil (including auto motor oil) will do for cuckoo clocks, and can just as easily be applied with a toothpick.

How long does a 340 Hermle clock movement last?

A size 8 key winds up both the 340 and 341 clock movements, a single wind lasts 8 days. In addition, it will be ready for installation upon arrival. The 340 and 341 Hermle clock movement series comes with an application of oil on it and is ready to go.

Where are the hammer heads on a Hermle clock?

The 340 and 341 Hermle clock movement series went through a change in the hammer wires. The hammer heads used to be on wires now they are made on flat bars. This is dealt with in the same way as above, it is just not as easy to bend. The hammer head is on the skinny end of the bar, the bar gets wider as it goes back toward the roll pin.

How do you wind a Hermle clock pendulum?

To wind the clock use the enclosed key. Turn key clockwise until it stops. The left winder is for the striking and the right winder is for the time. Hang the pendulum onto the pendulum leader as shown in the diagram below. Move the pendulum slightly to the left or right and release it gently.

What’s the difference between the 341 and 340 movements?

The older 341 and 340 series clock movements had the chime hammer head on wires instead of flat bars. The new style being sent will have the flat bars with the hammer heads on the end. It makes no difference to fitting the movement into the case, but it may make a difference as far as bending the rods to meet the chime rods.