Table of Contents
Can you replace axle shafts?
Front-wheel-drive vehicles get their power to the wheels by way of drive axle assemblies. As long as the axle is out of the vehicle, total replacement is a good call. Axle shafts can last for the life of you car or wear out sooner, depending on use.
How long does it take to replace an axle shaft?
It would take approximately 30 minutes to replace one axle. If a person actually wanted to repair an axle, if completely broken, then it would have to be welded. Welding an axle will not work, it weakens the steel to much to make it usable again. Front axles on most newer vehicles are a whole new game.
How much does it cost to replace an axle shaft?
Axle Shaft Replacement Cost – RepairPal Estimate. Labor costs are estimated between $157 and $198 while parts are priced between $723 and $761. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.
Is it worth replacing axle?
In most cases a bent axle cannot be repaired and must be replaced. A bad axle will lead to other damage to your vehicle down the line. So it’s critical that the axle be in great condition to avoid other costly repairs.
What are the symptoms of a bad inner CV joint?
4 Signs of a Bad CV Axle/Half Shaft
- “Clicking” Noises When Turning.
- A Knocking Sound.
- Grease on the Inside or Edge of the Tires.
- Vibration While Driving. This is a tricky one, since there are many things that could cause vibration when you drive.
Can you replace just the CV boot?
The Constant Velocity (CV) boots cover the CV joints and protect them from outside debris. If no noise is present and only the CV boot is broken, you can replace just the CV boot. Tip: Before you install a new axle, check the CV joints (even when the boot is broken) and see if they are worth saving.
Is it hard to replace an axle?
Replacing a front-wheel-drive axle is straightforward, although physically demanding. Get the replacement axle before you start, as well as a new spindle nut and a cotter pin or two. You’ll need both wheels off the ground to allow enough suspension droop. You’ll need a big socket to remove the spindle nut.
Should you replace both CV axles at the same time?
On a high-mileage vehicle with a bad CV joint or boot, it’s often a good idea to replace both shafts at the same time. Often, the right (passenger side) shaft fails first because right turns are at a sharper angle than left turns, and right turns are more common than left turns.
Is your car totaled if the axle is broken?
If the crash results in a broken axle, dented or tweaked pillar (the parts that “hold up” the roof, including the front windshield frame, the part between your front and rear doors, and the rear roofline), or extensive damage to the drivetrain or under-hood components, you could be looking at a total loss.