Table of Contents
What F150 axle ratio do I have?
How to Find Out the Axle Ratio on a Ford Pickup
- Open the front door on the driver’s side.
- Locate the Truck Safety Compliance Certification Label on the door pillar near the door latch.
- Locate the two-digit code in the box labeled “AXLE,” which is just below the bar code.
What does axle Code H9 mean?
The Ford F150 axle code H9 means that the vehicle has a 3.55 ratio and Limited slip differential.
How do I find my Ford axle ratio?
How Do I Find the Axle Ratio and Limited Slip of My Ford Vehicle?
- Locate the Safety Compliance Certification Label on the driver’s side front or rear door panel.
- Find the word AXLE under the bar code.
- Find the two-digit code under AXLE.
What rear end does a 94 F150 have?
As for the axles if they’re factory they’re a TTB Dana 44 front and Ford 8.8″ rear.
What is Ford axle Code 19?
Identify Your Ford Truck Axle From The Door Sticker
| Axle Code (Door Sticker) | Axle | Gear Ratio |
|---|---|---|
| 18 | Ford 8.8 | 3.08 |
| 19 | Ford 8.8 | 3.55 |
| 22 | Dana | 4.10 |
| 23 | Dana 60 | 3.54 |
How do I know what rear axle ratio My f150 has?
Locate the Truck Safety Compliance Certification Label on the door pillar near the door latch. Locate the two-digit code in the box labeled “AXLE,” which is just below the bar code. Match the code on the label to the corresponding rear axle ratio.
What is the axle ratio of H9?
The Ford F-150 axle code H9 indicates that the truck has a limited slip differential wit a 3.55 gear ratio. A limited slip differential has the ability to shift the amount of power to one tire or the other depending on the amount of traction and slippage that is occurring.
How do I find my axle ratio?
Method 1: Count the number of teeth on the ring gear and the pinion. Divide the number of the ring gear’s teeth by the number of the pinion’s teeth. This will give you the axle ratio.
How do I find my trucks axle ratio?
What is a 3.55 gear ratio?
Understanding Axle Ratios Technically, the number should be expressed as a ratio, such as 3.55:1, meaning the drive shaft turns 3.55 times for each turn of a wheel. But that gear ratio would most commonly be referred to as “3.55” or simply “three fifty-five.”
https://www.youtube.com/watch?v=QHpkl7phcoQ